Slip-line metal cutting model with negative rake angle

Basit Öğe Kaydı
dc.authorid0000-0003-3239-5943en_US
dc.authorid0000-0002-1377-9338en_US
dc.contributor.authorÖztürk, Sabri
dc.contributor.authorAltan, Erhan
dc.date.accessioned2021-06-23T19:29:26Z
dc.date.available2021-06-23T19:29:26Z
dc.date.issued2012
dc.departmentBAİBÜ, Mühendislik Fakültesi, Makine Mühendisliği Bölümüen_US
dc.description.abstractA small dead region is seen in front of the rake face of the tool during cutting with negative rake. The lack of knowledge about the stagnant region in the cutting with negative rake requires researching new models. In this work, cutting mechanism of the metal cutting with negative rake angle tools and the stagnation zone formation were studied. A model was generated from the experimental work by usage of the Dewhurst and Collins' matrix technique for solving the slip-line problem numerically. This model was applied at negative rake angles from 0 degrees to -70 degrees. All slip line angles in the slip line model that consist of three regions were resolved with the help of the experimental data. Variation of the dead metal zone and slip line regions with negative rake angle was determined. Effects of the negative rake angle on the cutting and thrust forces were investigated according to the cutting speed.en_US
dc.identifier.doi10.1590/S1678-58782012000300004
dc.identifier.endpage252en_US
dc.identifier.issn1678-5878
dc.identifier.issue3en_US
dc.identifier.scopus2-s2.0-84870376708en_US
dc.identifier.scopusqualityQ2en_US
dc.identifier.startpage246en_US
dc.identifier.urihttps://doi.org/10.1590/S1678-58782012000300004
dc.identifier.urihttps://hdl.handle.net/20.500.12491/7170
dc.identifier.volume34en_US
dc.identifier.wosWOS:000310852400004en_US
dc.identifier.wosqualityQ4en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.institutionauthorÖztürk, Sabri
dc.language.isoenen_US
dc.publisherAbcm Brazilian Soc Mechanical Sciences & Engineeringen_US
dc.relation.ispartofJournal Of The Brazilian Society Of Mechanical Sciences And Engineeringen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectStagnant Regionen_US
dc.subjectCutting Forcesen_US
dc.subjectSlip-lineen_US
dc.subjectNegative Rake Angleen_US
dc.titleSlip-line metal cutting model with negative rake angleen_US
dc.typeArticleen_US

Dosyalar

Orijinal paket
Listeleniyor 1 - 1 / 1
Küçük Resim
İsim:
sabri-ozturk.pdf
Boyut:
364.43 KB
Biçim:
Adobe Portable Document Format
Açıklama:
Tam metin / Full Text
İndir

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Makine Mühendisliği Bölümü Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu