Mechanical properties of friction stir butt-welded Al-5086 H32 plate
Yükleniyor...
Dosyalar
Tarih
2009
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Wiley-V C H Verlag Gmbh
Erişim Hakkı
info:eu-repo/semantics/openAccess
Özet
Al-5086 H32 plates with a thickness of 3 mm were friction stir butt-welded using different welding speeds at a tool rotational speed of 1600 rpm. The effect of welding speed on the weld performance of the joints was investigated by conducting optical microscopy, microhardness measurements and mechanical tests (i.e. tensile and bend tests). The effect of heat input during friction stir welding on the microstructure, and thus mechanical properties, of cold-rolled Al- 5086 plates was also determined. The experimental results indicated that the maximum tensile strength of the joints, which is about 75% that of the base plate, was obtained with a traverse speed of 200 mm/min at the tool rotational speed used, e.g. 1600 rpm, and the maximum bending angle of the joints can reach 180 degrees. The maximum ductility performance of the joints was, on the other hand, relatively low, e.g. about 20%. These results are not unexpected due to the loss of the cold-work strengthening in the weld region as a result of the heat input during welding, and thus the confined plasticity within the stirred zone owing to strength undermatching. Higher joint performances can also be achieved by increasing the penetration depth of the stirring probe in butt-friction stir welding of Al-5086 H32 plates.
Açıklama
Anahtar Kelimeler
Friction Stir Welding, Al-alloys, Joint Performance, Strength Undermatching
Kaynak
Materialwissenschaft Und Werkstofftechnik
WoS Q Değeri
Q4
Scopus Q Değeri
Q3
Cilt
40
Sayı
8
