An experimental study on dead metal zone in orthogonal cutting with worn rounded-edge cutting tools

Basit Öğe Kaydı
dc.authorid0000-0002-5513-4431en_US
dc.authorid0000-0003-3239-5943en_US
dc.authorid0000-0002-1377-9338en_US
dc.contributor.authorUysal, Alper
dc.contributor.authorÖztürk, Sabri
dc.contributor.authorAltan, Erhan
dc.date.accessioned2021-06-23T19:42:28Z
dc.date.available2021-06-23T19:42:28Z
dc.date.issued2015
dc.departmentBAİBÜ, Mühendislik Fakültesi, Makine Mühendisliği Bölümüen_US
dc.description.abstractA dead metal zone is formed by the negative rake angle effect of the rounded-edge and it affects the cutting forces during machining operations. Therefore, investigating the size of the dead metal zone and changing it with cutting edge radius and flank wear rate are important. In this study, the dead metal zone was investigated experimentally for unworn and worn rounded-edge cutting tools and it was defined by changing the flank wear rate and cutting edge radius. It was observed that the size of the dead metal zone increased with increase of the cutting edge radius and it became smaller with increasing the flank wear rate. In addition, cutting force and thrust force were investigated. It was proven that both forces increased with increase of the cutting edge radius and the flank wear rate.en_US
dc.identifier.doi10.1504/IJMPT.2015.072574
dc.identifier.endpage412en_US
dc.identifier.issn0268-1900
dc.identifier.issn1741-5209
dc.identifier.issue4en_US
dc.identifier.scopus2-s2.0-84946237070en_US
dc.identifier.scopusqualityQ3en_US
dc.identifier.startpage401en_US
dc.identifier.urihttps://doi.org/10.1504/IJMPT.2015.072574
dc.identifier.urihttps://hdl.handle.net/20.500.12491/8498
dc.identifier.volume51en_US
dc.identifier.wosWOS:000366047200007en_US
dc.identifier.wosqualityQ4en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.indekslendigikaynakScopusen_US
dc.institutionauthorÖztürk, Sabri
dc.language.isoenen_US
dc.publisherInderscience Enterprises Ltden_US
dc.relation.ispartofInternational Journal Of Materials & Product Technologyen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectDead Metal Zoneen_US
dc.subjectRounded-Edge Cutting Toolen_US
dc.subjectWorn Cutting Toolen_US
dc.subjectOrthogonal Cuttingen_US
dc.subjectCutting Forceen_US
dc.subjectThrust Forceen_US
dc.titleAn experimental study on dead metal zone in orthogonal cutting with worn rounded-edge cutting toolsen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Makine Mühendisliği Bölümü Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu