Metallographic analysis of the dead metal zone in metal cutting with a rounded-edge tool
Küçük Resim Yok
Tarih
2013
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
De Gruyter
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
The experimental results show that a small dead region is seen in front of the rake face during cutting with a rounded-edge cutting tool. Although this fact was accepted, metallographic analysis of the dead metal zone had never been conducted. A quick stop device was used to obtain chip root samples that are representative of the deformation taking place during dynamic (actual) cutting conditions. A metallographic analysis was performed on selected specimens to identify the microstructure and formation. The photomicrographs were analyzed and an effort made to explain the dead metal zone microstructure.
Açıklama
Anahtar Kelimeler
Metallographic Analysis, Metal Cutting, Rounded-edge
Kaynak
Praktische Metallographie/Practical Metallography
WoS Q Değeri
Scopus Q Değeri
Q3
Cilt
50
Sayı
5
